Raceland: Looking to know how to install your new VW Mk4 coilovers? Take a look at
our newest install video!
#VW #mk4coilovers #mk4install #mk4golf #mk4jetta
Ghost Wartek: Do OEM strut bolts come with an order of coilovers?
LogicXProductions: Just heard about your company yesterday from my friend, and I will be
purchasing in the near future. Will you be making any videos on how to
install on a 99-04 Mustang GT? Would really like to see one before the
Raceland: We are working on a video now and should have it posted shortly.
Raceland: The install on any MK4 will be very similar.
Cooper Power: Anyone have part #s for the oem parts needed for install?
Raceland: When you lower the car, the camber will become more negative.
Raceland: The lubricant used was a anti-seize grease.
Jeep19XJ91: Just installed these on my mk4 jetta and they are awesome, only problem i
had was the passenger side slid down in the hub thing and took out the cv
shaft boot. Kinda my fault since i forgot to get the replacement bolts. But
as a side note, the paper that came in the box stated 45 ft/lb for the
torque spec, vw says 60nm (45 ft/lb) PLUS an additional 90 degrees, no less
than 90.. Great product though, would definately buy again if i had to
muscleammo: omfg you guys are awesome
YouDontKnowMe: yes they will. You'll have to realign the wheels.
mronemanband1: did you have to take axle nut off and lower control arm bolts out and pull
spindle out for clearence?
aetommyboy: Thanks for the post!
joshuafrye182: Will these affect the camber of the wheels?
plorwax: do i need to change any other parts when doing this to my mk4 gti? like end
links and other stuff to prevent rubbing? sorry im a nood at this
Raceland: Here are the part numbers for the lower stretch bolts you will need from
Volkswagen. -N10207804 (2 are required) -N10106402 (2 are required)
Raceland: Depending on the height, you will need adjustable endlinks to keep the sway
bar from rubbing on the axle.
Ernesto Martinez: is this the same method of installation for any coilover set on an MK4?
Flipaish: How different is the installation on the Mk4 to the Mk6? Anything I should
Raceland: Our Ultimo kit will lower the car roughly 4 inches below stock height.
Raceland: We didn't.
IMSOSEXYPRODUCTIONS: I've had these coilovers for 2 and a half years and im not gonna lie I
Trash the crap out of them because they were only 400 bucks and i figured i
get better ones later on. but that changed after my warranty went away i
looked at them and there still in full 100% working condition, i have done
numerous mountain runs hit hard potholes and hey they still hold up good,
GOOD job raceland you have my two thumbs up
alonelyjackal: If you have a Mk4 with a 2.0L you will need an aftermarket sway bar with
adjustable link-its or else your Sway Bar will rub on your wheel axles this
is if you drop your car lower than 1.4''
Hemshemsems: I would pick up new topmounts and bearing for the front suspension, they do
wear out pretty easy and a lowered and hard suspension only makes them wear
out even quicker... I also finish the installation with a spray of oil
treatment on the coil and locking perches, its alloy againts galvanised
steel, and galvanic corrosion will make it hard to get apart later on.. I
wbd810418: Nice work mate!!
Richard Gaona: Thanks for the post!! Finally a decent video on Youtube showing how to
install coilovers to a MK4 Golf!
SalsaG93: what lubricant was used at 02:30 ?
Brandon Poe: hahaha really digging the ronald jenkees i got mine put on last week and
I've never been happier
Raceland: The install is a lot the same but the nice thing about the MK6 is that the
front upper strut mounts are less complicated.
Raceland: We will be shortly. The install is similar to the MK4. The only difference
is that the front upper strut mounts are a lot less complicated.
Tiara Benjamin: any chance you are going to post a video on the gti mkv?
wursta007: about time
Raceland: Depending on how you low you plan to lower the car, you may need adjustable
end links as the sway bar can come in contact with the axle. Other than
that, you will just need to re-use or replace the OEM upper strut mounts
and the lower stretch bolts for the front mounts.
Blog Dir: Building the website was not the hard part, but monetizing it was a whole new story. Thanks for the guidance about adsense. I am finally getting some money for my business directory. This is good for both business owners and customers. Keep building quality site and everyone wins.
How To Install Raceland VW MK4 Coilovers4.7
out of 5