Build: Dual Coils & What You Need To Know




What do you think about this video?

Michael Heiser: my one coil is lighting up quicker than the other... any thoughts? I need some help, please.

Paul Woolard: Hey man when I don't have cotton in my coils both fire fine and turn orange at the same rate then when I put cotton in it only one wants to fire and turn orange. Any suggestions?

huhhman: Worst build i've ever seen. Sorry....

Kristi Wilson: I have a nimbus with three posts. Mine hits great for about a minute then nothing. I have several different batteries. My coils are very nice too. Any suggs?

lucky_x16: Some people should never do videos, especially if they have a voice like a grade school history teacher, and then if they are putting out information that could get people hurt.

Inkki89: Can you use any kind of iron wire to make the coil?

Richard Michael: You would DO WELL to use an OHM Checker.... every time.

Shawn Elliott: I love your intro! wow

JamieD262: what i would recommend to all newcomers and well everyone is to use an ohms meter (£15 online, lasts years, most VV/VW mods have one built in) before you attempt to fire up a new build, diving into RBA's is something advanced users should do, definatly when using a mech mod, ensure you have a High Drain/high Amp battery if youre sub ohming too.

Keith Joshua Balayan: Sir can I dual coil a two pole atomizer and do you think my sigelei zmax will be able to handle it? Thank you so much sir and more power to you.

Alex Martinez: can i build this on a AW IMR 18650 3.7v 1600mAh on a stillare clone?

Phoenix-Brian Priester: Thanks for the advice! Wish there was a chart for gauges to wraps as a guide. My first dual coil build on an IGO-W came to .6 and my SVD wouldn't fire it. Perfect micro coil, but what was the real problem, I was given a length of Kanthal without asking what gauge... Free is free.

Arthur M.: Hi, I bought a soldering iron and it stop heating up. I then open the soldering iron and one of the soldering iron heating element wire was broken. I want to know if I could joint a piece of Nichrome Resistance Wire so that it could work again, or can you tell me how to mend it. I bought this soldering iron like two weeks ago but I lost the receipt.

Biosystem Studios: I have a LD Igo-W and it has the negative post in the middle so if I'm getting this right then that should be the only one that has 2 wires running through it right? The outer positive posts should each have one for each coil?

Ethereous: Holy freak, that stupid, long-ass intro that no one gives a freak about.

Peter Polizzo: send me one of those =)

Hunter Weintre: Lol i feel like an idiot, i never knew that you could put dual coils on a 2 post RDA. gonna start building dualies as soon as i drill out a second hole

Courtney D: those are some crapty ass punto lunto ass coils

Tim Quesada: Thank you for the advice M.C. Vapes.

vincenzo formosa: What voltage battery would you recommend for a mechanical mod with a dual coil. Looking at .5-1 ohms? Does it matter?

amir benglisa: i just bought a kamry k100 what do you think i have to do to make big clouds? should i use the cartomizer that comes with it?

Tim Quesada: How do you avoid a short on RDA's ?

CashRockThunderMamal: I do not like this RDA at all. So glad I got an Omega. 

Sveinn1984: Great video, thanks for the tips!

macker33: would look good on a black tesla

ZeRo2o9: what do you reccomend on wire & wick for the nimbus? Im a beginner trying to learn I just want to change the wicj that it came with

Jay hernan: Thanks for the video! Just subscribed. Just bought the hammer mod with the Patriot clone. But no wick or coils.. You think cotton is better that silica? Also.. Why are there other people that do like 7 wraps and torch the wire? 

cameron telford: So im planning on picking up the stellare RDA today which has 3 posts and going for my dual coil build this afternoon my biggest question and consern is shorts I have done alot of reading on it and cant find any information on what causes shorts. Please help haha

Allan Goco: How about 4 wraps of 20mm Kanthal just to be on the safer side, will that produce as good a vapor?

Tim Quesada: BTW, thanks for sharing. I'm a newbie on dual re-coiling.

Tommy McFarlin: Great vid. Ready to start building my own!

Blaine Carter: can i pay u to make me one

Carlos M: Whats up MC vapes! I am using an aspire by nova with a dual coil and i also just got the aero dual coil by kanger tech. I wanted to rebuild the atomizers and came across your video. I on the aspire they have negitive resistance on the end of the coil wires. Is that needed for the aero kanger dual coil ? If not why is that ? Thanks

Robert Stanley: Here's an idea unless you already tried it, how about a quad coil on a nimbus? 

nathan mccully: thank you your video helped me to do my first successful build I did a 3 coil rap for each coil with double silica wic once again thank you

liza dickson: nice vid but what about the risk of over working your battery and causing thermal meltdown..vent gas or BOOM! ?? er.. the c rating of your battery is? how many amps does that setup use? If people burn themselves multi coiling, this could be used againt us.

Anthony Carrillo: Biggest help iv had thus far thank you

Ben Pena: Thanks for the tutorial bro.

hquiroz113064: dot worry about uncle bob there he is just pissed about nothing!

MissKarizma: Thanks for the tutorial, gonna try this tomorrow :) 

Bob Starr: I thought that this was a coil winding trick to generate Free Energy...

Justen Annuar: thank you very much

Andy B: I have a question for you M.C. Vapes I have recently entered the world of RDAs, and made my first set of dual-coils on a chinese knock-off Nimbus clone, which worked perfectly. I ran into a problem where when I used 28g Kanthal A1, by the time you twisted the filament wire up (to get more surface area), the diameter of the two coils together into the centre post was too large to pass through the hole in the post. To alleviate this I can drill them out, but if I go too large I run the risk of drilling the threads clean off .. I've already ruined one by going up to 1.5mm, it was the only drill I could get, but I was thinking if I went up to 1mm-1.2mm it should be ok. My question is .. do the genuine Nimbus RDAs have larger holes (larger than 1/4"), and larger screws ? Have you run into this problem already ? Thanks Andy B

knz9701: I'm a NEWBIE to wrapping coils.. I don't understand the whole bits tool yet, though I'll be more excited about it laters… Thanks for making this video, I did a trial run and my wraps were too lose.. Than I did exactly what you did in the video and this one works for me, one side came out perfect and I had to tweak the other side but for a 2nd time wrapping it being a newbie I'm pleased with it.. I really appreciated this, mahaloz from the "Big 808"!

Zori Marfazelian: how do u know when u need to redrip as in how do u know u burned through your juice so u can refill it???

Tony Reynolds: Great video...just liked and subscribed ! Thanks for sharing ! !

Eli Carrillo: Hi, I just liked and subscribed!!! I wanted to know what do you use to measure the resistance of your coils before you vape.. And also where did you buy it???

Dustin Frisbie: Thanks for the tutorial, i been attempting my first dual coil build and for the life of me could not figure out why I was not getting the good hits and clouds as I was with my single coil.

Bob Starr: Glass does not bio-degrade in your lungs. Your going to get black lungs.

Rating:
Build: Dual Coils & What You Need to Know 4.5 out of 5

Shared by Others

WWE RAW Review 3-9-15 - WrestleMania 31 build starting to take course?
WWE RAW Review 3-9-15 - WrestleMania 31 build starting to take course?
Lego The SIMPSONS HOUSE 71006 Stop Motion Build Review
Lego The SIMPSONS HOUSE 71006 Stop Motion Build Review
Taifun GT 2 RTA Review + Build
Taifun GT 2 RTA Review + Build
LIAN LI TU-100 Build Review By Wise Guys Reviews
LIAN LI TU-100 Build Review By Wise Guys Reviews
LEGO MINECRAFT - Set 21118 THE MINE - Unboxing. Review. Time-Lapse Build
LEGO MINECRAFT - Set 21118 THE MINE - Unboxing. Review. Time-Lapse Build
Jeunesse Reviews   How To Build A Big Jeunesse Business
Jeunesse Reviews How To Build A Big Jeunesse Business
BPI Build HD Creatine Reviews
BPI Build HD Creatine Reviews
EHPRO Kayfun Lite Plus V2 Coil Build and Review   VAPEFOG
EHPRO Kayfun Lite Plus V2 Coil Build and Review VAPEFOG
LEGO Friends Heartlake City Pool - BUILD and REVIEW
LEGO Friends Heartlake City Pool - BUILD and REVIEW
Rodan and Fields Reviews   How To Build A Big Rodan and Fields Business
Rodan and Fields Reviews How To Build A Big Rodan and Fields Business
LEGO Ninjago Battle for Ninjago City 70728 Build & Review
LEGO Ninjago Battle for Ninjago City 70728 Build & Review
Dark Horse Review and Dual Coil Build   VAPEFOG
Dark Horse Review and Dual Coil Build VAPEFOG
Orchid v4 overview and quick build
Orchid v4 overview and quick build
CaseLabs Mercury S5 (+Pedestal) Review & Watercooling Build
CaseLabs Mercury S5 (+Pedestal) Review & Watercooling Build
Reliv   Reliv Reviews - How To Build A Big Reliv Business
Reliv Reliv Reviews - How To Build A Big Reliv Business
454 BIG BLOCK RDA (English) & Build Tutorial by KRYPTONITE - VIENNA VAPER REVIEWS
454 BIG BLOCK RDA (English) & Build Tutorial by KRYPTONITE - VIENNA VAPER REVIEWS
Airfix LEGO Compatible Spitfire Build and Messerschmitt 109 Fighter Plane Reviews
Airfix LEGO Compatible Spitfire Build and Messerschmitt 109 Fighter Plane Reviews
LEGO Movie MetalBeard's Sea Cow 70810 Build Review & Comparison
LEGO Movie MetalBeard's Sea Cow 70810 Build Review & Comparison
Mannatech Reviews   How To Build A Big Mannatech Business
Mannatech Reviews How To Build A Big Mannatech Business
NZXT H440 Green Unboxing Review and Build Timelapse
NZXT H440 Green Unboxing Review and Build Timelapse

Featured Video

How to Make Money Online


Build: Dual Coils & What You Need to Know