How To Install Replace Ignition Key Lock Cylinder Chevy Venture Trans Sport 97-98 1AAuto.com




What do you think about this video?

james felicetty: Well what if I lost my key 

Adam Cole: So I installed a new key cylinder in my 2001 Grand Prix that I bought from a dealer. I place the new cylinder in and now the key wont turn all the way off. I was worried so I placed the old one back in and the same thing happened. So I am stuck on how to get the key to turn ALL the way off to pull the key out without pushing the key release plunger behind it. Any ideas or thoughts that would help would be greatly appreciated. Thank you.

J Law: Having an issue where my venture wont start, Unless you tap on the steering colom with something. I followed the directions on here an replaced the key. But it is still doing the same thing. What should I be looking at in here to fix this issue?

Belinda Rea: Thank u so much !! Just changed the one in my 02 chevy trailblazer! It was a piece of cake!

WPatrick Kendrick: Thanks for your help-saved me a lot of time. I was able replace the key cylinder, just like the video. Thanks again.

Belinda Rea: Thank u so much !! Just changed the one in my 02 chevy trailblazer! It was a piece of cake!

1A Auto Parts: @lildouzie100 You may need to have a locksmith take a blank and cut one for you. They might be able to do this.

1A Auto Parts: By changing out the lock cylinder, you will solve the issue. Over time the teeth inside the switch wear down and they can no longer read the key correctly so it does not release it after you turn it.

kandleguy87: how do i take the ignition out if my key doesnt turn

1A Auto Parts: Thank you for visiting our auto repair channel on YouTube. We currently do not have a tutorial video on this particular repair. We'll keep this in mind, if we end up making this repair in the future. If you have a Chiltons or a Haynes repair manual, it should show you how to remove it in the book.

1A Auto Parts: @OutragousGaming It sounds like the tumbler may have broke. You could try to replace the ignition on it. Hope this helps you out.

Rob88Flyer: Hey Mike - Great video. I have a 99 Pontiac Montana and sometimes the key gets stuck in the ignition. So far I've been able to get it out each time by starting/stopping or turning the wheel or messing with the gear shift - but I fear my luck will run out. Will changing the lock key cylinder solve the problem? Thanks for posting these great videos.

1A Auto Parts: Thanks for watching!

1A Auto Parts: It shouldn't be too bad. We carry a replacement on on our website 1aauto.com Part Number: 1AZIS00014 if you would like to see what we have. This one is for the column mounted shifter only.

crazynorteno14: Thank for the video buddy

princeC209: What if I dont have the key yo turn it! Would I be able to get the cylinder out still. . . I lost my keys

Josh Heflin: How would you do it to a 77 Chevy nova?

Nick Skalla: I need help with a 98 bravada.. Do you have any videos??

1A Auto Parts: @TheKinfo23 We'll keep this in mind if we make this repair in the future. Thank you for visiting our auto repair website.

Mel Riley: I have a 2002 chevy venture. We believe the engine switch is the problem because we you cut the car off, the air conditioner blower comes on and the automatic lights. You have to jiggle the key to get it to go off. How difficult is it to replace the actual switch?

lildouzie100: how to change the key ignition if you lose the key to the ignition

1A Auto Parts: You could try to wiggle the key up and down while you turn the wheel to see if it frees it up for you.

1A Auto Parts: @TNredneck84 We show how to remove the ignition if your current one is sticky and you have the key. I'm not aware of a away to remove it without the key.

1A Auto Parts: @infinitepain951 Thank you for checking out our YouTube videos. Have a great day.

satanas estrada: greetings hello a question .. how I can remove the headers of the seats in 1998 olsmobile silhoette. I would greatly appreciate it

1A Auto Parts: We currently do not have a video that shows you how to do this if the tumblers are broken. We'll keep this request in mind in the event that we need to make this type of repair in the future. 1aauto.com 888-844-3393

solardragon223: Hay Mike, fist, thanks for doing these vids. My roomates boyfriend has a 2000 chev s-10. The key cylinder wont turn, we tried both sides of the key, wiggling it and all..The steering wheel is locked, it wiggles minutely. And the shifter wont budge. Thanks again in advance for any tips or help you can give...

TNredneck84: @1aauto he says you cant get a code for GM models before 98 or something like that. thats why they had to destroy it to get it out. is there not an easier way if you cant get the code? it seems this way is pretty violent and breaks things that probably shouldnt be broken....hope you can help!

boinkz572: i was in the same situation as you lost the key, and none of the others i had made worked, so i took off the parts like 1aauto recommends, i pulled the black plastic off the end of the switch, where your key goes in, then took some vise grips on the end of the metal part and moved it back and forth till it got free to to sin around, then used a small allen to push the tab down, and it popped right out! THANKS A MILLION 1AAUTO, YOU SAVED ME A CRAP LOAD OF TIME! 5 STARS TO YOU BROTHA!

kgill113: I can't get my key to turn forward to the on position. Can I still get the key out?

1A Auto Parts: @kandleguy87 You would need to somehow get the key to turn forward. If you haven't, try to wiggle the key up and down as you turn it forward. Also you may want to make sure that the steering wheel is not locked in place. Hope this helps you out.

1A Auto Parts: It may be getting worn.

Dontwannagivemyname: Wow, you guys really do a fantastic job on these videos. Thanks.

Rheygand: what would be the reason to replace they ignition key lock cylinder?

irishmandd: Hi I have a 2007 ford transit van. when key is in ignition the gauge goes crazy and makes a funny sound . Also have to open door manually. Any suggestions.

Luke Randolph: how would it work if your ignition was sabotaged?

1A Auto Parts: It could be the issue. We currently do not have an auto repair video that shows this particular repair. We do carry new key lock cylindars for your 96 Chevy Astro van on oue website. 1aauto.com 888-844-3393

Crete Monsta: Would this work with a 98 chevy lumina base model. 3.1L I have two ignition cylinders hooked up and need to get it down to one

1A Auto Parts: @LilWinn19 You may want to check the wiring to see if there's a frayed wire.

Jwalking713: Do a Chevy silverado .

Matt Watkinson: I think I need to replace the lock cylinder in my 2001 Chevy Astro van. The other day when I took the key out, the engine was still running.

LilWinn19: very helpful video! It was very easy to do but im still having a problem.. i bought a brand new cylinder and installed it. the acc and on position works fine but it wont start but when i put the old one back in the it starts fine.. so today i went to the junk yard and found one with the key still in it and installed it with the same results. no start... what you think?

1978randomhero: Thanks alot for this video!! It was very easy to follow and also you guys just saved me alot of money, thanks again. I've been following you guys and every video is very educational and self explanatory.

1A Auto Parts: Thanks for checking us out. Have a great day! 1aauto.com 888-844-3393

1A Auto Parts: Unfortunately you need to be able to turn the tumbler in some way for the cylinder to be removed.

emoXodus: is there a tutorial to do this with an older chevy? ive been at it for 2 days already trying to get the cylinder and the turn signal switch on my 89 caprice 305 classic

George Beckingham: My son stuck a paper clip deep into the ignition, so I can't get my key inside. Is there a workaround for this situation?

1A Auto Parts: Hi John, You shouldn't have any issues with the air bag going off. You could disconnect the battery, and that would take car of any electrical concerns that you might have while working on the vehicle.

1A Auto Parts: @WillieHatesDQ You would need to find a way to get the tumbler to turn in order to remove the switch. You could try to jiggle the key while you turn the ignition to see if this helps.

1A Auto Parts: If you can't get it to turn, you might have to have a locksmith remove it for you, if it's stuck in place. 1aauto.com 888-844-3393

Rating:
How To Install Replace Ignition Key Lock Cylinder Chevy Venture Trans Sport 97-98 1AAuto.com 4.4 out of 5

Shared by Others

How To Install Replace Broken Side Rear View Mirror Chevy Venture Pontiac Montana 97-08 1AAuto.com
How To Install Replace Broken Side Rear View Mirror Chevy Venture Pontiac Montana 97-08 1AAuto.com
Ignition Lock Cylinder Replacement (late model GM Trucks)
Ignition Lock Cylinder Replacement (late model GM Trucks)
How to Replace Ignition Switch in 95-98 Silverado & Sierra
How to Replace Ignition Switch in 95-98 Silverado & Sierra
Replace 1999-2005 Pontiac Montana Headlight / Bulb. How to Change Install 2000 2001 2002 2003 2004
Replace 1999-2005 Pontiac Montana Headlight / Bulb. How to Change Install 2000 2001 2002 2003 2004
S10 Lock Cylinder Starter Switch Install Replacement
S10 Lock Cylinder Starter Switch Install Replacement
How to Install Replace AC Heater Fan Blower Motor 1997-2013 Chevy Express GMC Savana
How to Install Replace AC Heater Fan Blower Motor 1997-2013 Chevy Express GMC Savana
How to program a transponder key GM Chevy Buick Saturn Oldsmobile Pontiac Van
How to program a transponder key GM Chevy Buick Saturn Oldsmobile Pontiac Van
How To Install Replace Ignition Coil GM 3800 3.8L Grand Prix Monte Carlo Impala 1AAuto.com
How To Install Replace Ignition Coil GM 3800 3.8L Grand Prix Monte Carlo Impala 1AAuto.com
Pontiac Key Release Ignition Problem / Workaround / Fix
Pontiac Key Release Ignition Problem / Workaround / Fix

Featured Video

How to Make Money Online


How To Install Replace Ignition Key Lock Cylinder Chevy Venture Trans Sport 97-98 1AAuto.com