HOW TO ADJUST CARBURETOR On Craftsman Hedge Trimmer




What do you think about this video?

Sam Brako: Cool Vid. Thumbs up!!

Dennis King: Good Vid but unfortunately The fags at RYOBI decided to make their carb adjust bolt Impossible to adjust without a special tool that you cant buy at a hardware store called a pacman. wwwttffff

rockmanted: Thank you very much for posting. I had a different engine and it was on a tiller, but it was close enough that I could use what you taught me to get it from "races, then quickly dies" to "runs as good as new". Thanks again.

sandydogy: Great video thanks is this the same to set lawnmower carbs?

donyboy73: check the clutch

donyboy73: make absolutely sure it's venting and make sure the needle valve lever is set properly, i do a pressure test on the carb

S8ilor: Brilliant vid

FishFind3000: I have a craftsman weed wacker and I can't get it to run without using the choke 60% on the whole it I'm running it do I need to get it repair at a shop or start checking and cleaning?

70jafos: donyboy muchas gracias for your video

donyboy73: vous etes Bienvenu

Timothy Connor: I have a Murrey select 4.5 and the engine revs up and down do you no how to fix.

donyboy73: thanks for watching

Chewwy153qt: Can you make a video, if possible, for sharpening trimmer blades?

donyboy73: try adjusting the carb and or replace the carb kit

donyboy73: @6013welder homelite made those and sears put their label on it

Markie Musicmaker: I hope u can help me fix mine too ! It runs but the blades don't respond when I pull the throttle , the blade may engage when it feels like it ! It's been oiled & greased ! What's is the problem with it & how to fix it ? Thanks !

Scott Bunney: Ok, thank you sir.

th19940305: good video, i sometimes try to adjust some that wontseem to run right on any adjustment, any ideas, and they have a clean carb

donyboy73: @Jkajwang you're welcome

donyboy73: @gpzDave some might have them

ianvaldivia1993: @donyboy73 that model is made by homelite

Paul Martin: Thanks alot. Very good lesson and will use for a long time to come.

Scott Bunney: Hey Dony. I just rebuilt a 272xp, as well as its Tillotson carb and have had problems with adjustment. Seems that there is access fuel pressure from the fuel line out of the tank. The vent works. I can get it running, but when I shut it off within a few minutes, gas builds up in the air intake area. The only way I can get it to run at that point is to pull the gas line out of the carb, run the carb out of gas, then when I hook the fuel line back up, it floods out. Any ideas. Thanks.

ianvaldivia1993: that model is made by homelite

donyboy73: thanks for watching

donyboy73: @Smallgasengine1 looks like homelite

Michael Vink: Great video as usual. I have one of these exact trimmers, but it's missing the carb. Do you know what model number Walbro carb I will need to get it running? Thanks.

Jkajwang: Very well done. Thank you for a great demo and kindness.

MAAAH1581: thank you thank you thank you thank you thank you thank you thank you i learned alot from this video thank you dony

Zack Everett: don whats the difference between the idle screw and the low screw

1972FordF150: Cool video man ! thumbs up !

chox2001: very informative

Rating:
HOW TO ADJUST CARBURETOR on Craftsman Hedge Trimmer 5 out of 5

Shared by Others

HOW TO ADJUST CARBURETOR on Craftsman Hedge Trimmer
HOW TO ADJUST CARBURETOR on Craftsman Hedge Trimmer
HOW TO CLEAN A Craftsman Trimmer Carburetor Part 1/2
HOW TO CLEAN A Craftsman Trimmer Carburetor Part 1/2
HOW TO ADJUST The Carburetor on Weedeater XT260 Grass Trimmer
HOW TO ADJUST The Carburetor on Weedeater XT260 Grass Trimmer
How to Clean a Carburetor on a Small Two Stroke Engine
How to Clean a Carburetor on a Small Two Stroke Engine
HOW TO SHARPEN HEDGE TRIMMER BLADES
HOW TO SHARPEN HEDGE TRIMMER BLADES
Part 1 Echo Trimmer Repair
Part 1 Echo Trimmer Repair

Featured Video

How to Make Money Online


HOW TO ADJUST CARBURETOR on Craftsman Hedge Trimmer