coyotesaftau too: New York Dashes for the wood kit. It is real wood and warms up the gray plastic interior a little.( Spinners next !) The trick to removing the large plastic piece is to pull it hard !!
sam lubinsky: Wood dash in a elantra!! Lmao hahaha omg please put spinners on next
Christopher Solveson: How easy was the wood kit to install? And where did you get it?
Anthony Brown: did you need a antenna adapter? and if so could you tell me where you purchased it?
ThePariss333: Any one can tell me how to remove the glove box housing, that plastic holding the glove box on Elantra 2008 ? I removed all screws and nuts 3 screws top, two nuts and a screw at the bottom and three screw at the right side on the air vent and still doesn't come out. I even two screws at air vent and the air vent doesn't come out, so it doesn't allow move the upper glove box. Thanks for any help.
Sling Raccoon: I swear videos like this are so NOT helpful!
I mean it's better than nothing, but I hate when the instructor is like "ah most of it is already done". How is that supposed to help us.
You didn't even show how you detached the clock wires and the 2 next to them. Oh right, because it was already done. Well its not done already for us!!
Sorry, this is just kinda frustrating me, ya know?
pitwhip: Thanks! this helped me out a lot.
KantoeLegit: I'm really scared I would mess up my dash or some wiring. Is it possible to get this done by a professional or does it have to be manual?
Amy Eachus: Yes this was extremely helpful. My old Cavvy was like a Fisher-price set up so when I saw that you had to pry off part of the dash in the Elantra I got discouraged. Thanks for the video!
coyotesaftau too: I just searched " Hyundai Elantra stereo harness" It is the $7 harness with a single white plug.
Keven Hains: Can you send me a link where they sell the wiring adapteur on ebay ? For a hyundai elantra gt 2003 !
coyotesaftau too: You're welcome ! I watched the VERY LONG other videos. I found out that it is very easy and takes about 10 minutes !
Guillermo Murua: thanks buddy, your video is far better than the other one they have on youtube. very helpful !
coyotesaftau too: There are only 4 screws then the bezel pulls out with a little prying and effort.. The bulbs by the ashtray must be twisted then pulled out. The wiring adapter purchased on ebay exactly matches the wire colors of the Kenwood stereo, so they solder directly together. I didn't buy the installation kit since the little storage tray screws to the radio and it all fits perfectly.
Removing replacing installing 2001 2002 2003 Hyundai Elantra radio or stereo5
out of 5