TL-WR741ND OpenWRT Recovery RS232

What do you think about this video?

Павел Цыденов: Thank you VERY much. Some addition. PuTTY Category\Serial: Speed - 115200; Flow control - none.

oscar villace: Mientras actualizaba el firmware en mi Router TP-Link TL-R470T+ V3 se cortó la energía eléctrica y NO he podido volver a acceder a mi Router. Podré flashearlo con un proceso parecido al que muestras aquí..?Gracias. Oscar

EMAD: Маршрутизатор приветствовали 41 п паром свет только из-за плохого Как я должен просить обслуживание

Наталья Варлей: ЛОХ

MrMilanoLau: I followed your instruction, but when I type "firstboot", it just says "MTD partition not found".


Marcos josue Licett Andrade: should the router connected to the adapter or the power gives the usb port?

Rodrigo Gomes: tks!

Manolais: idem, you fix that problem?

Everson Santana: I have tp link 741nd v.4.20. I connected the wires to the same video. When I open the putty, nothing happens, it is a small box in the left corner. What can it be? Use the cable ca-42 installed right on computed. Thank you.

Hafizi Ibrahim: it is the easiest way to get USB TO TTL cable.It contains FT232 chip which act as voltage level converter between your PC +5V and the router serial port +3.3V .You can use any cable that contains FT232 chip and looks at the pinout for the correct connection.Please correct me if im wrong.Still newbie in EE.Thanks.

Luuk van A: Thank you so so much man!!!!

hkrware Youtube: anyone got any idea if this would work on a standart serial port without the ca-42 cable?

MrVestek Productions: What is the name of the prong connector you connected the wires to? Thanks.

vedranart: Hi, can you plz explain me why everyone uses CA-42 cable, why you can't use any other USB cable and connect it the same way? I mean, does this cable have some chip inside or what? Why I can't use an micro usb, or iPhone/iPod cable the same way? Thank you! ;)

duhml: hello tomi, did you had to take any special precautions regardin reassemble? because i debricked a router like yours but now the signal strength is pretty lower than expected...i suspected it was related to the bad coupling between the gray wire and the connector but after some squeezing no improvements were noted. What do you think? Thanks in advance

Zetanor: But did you run the CD first?

Tomi OZ: loking in Device Manager on where port working masz com, for me it works on com11 and so the link by putty. greets from polish

Vitaly Nazarov: Hi there! Tomi help me plz! I'm doing exactly like you do in your video, but then I try to connect via putty (COM1 or COM2 and 115200) nothing heppens . It is just appears black window and nothing heppens at all. Any ideas? Do you use somthing else drives or progs? May be some drivers usb-to-com, or drivers or Nokia? Respect from Ukraine =)

Don ™: Adam Drake & Neil Williams - Red Moon

Schools: Learn how to get phlebotomy training in California! The job pays decent money for the amount of schools needed to graduate.
TL-WR741ND OpenWRT recovery RS232 5 out of 5

Shared by Others

Test Drive: 2010 Acura TL SH-AWD 6-Speed
Test Drive: 2010 Acura TL SH-AWD 6-Speed
2012 Acura TL SH-AWD Reviews & Auto News - Car Pro
2012 Acura TL SH-AWD Reviews & Auto News - Car Pro
TL Ultralights Sirius TL3000 light sport aircraft pilot review PART 1.
TL Ultralights Sirius TL3000 light sport aircraft pilot review PART 1.
2014 Acura TL Reviews get details and
2014 Acura TL Reviews get details and

Featured Video

How to Make Money Online

TL-WR741ND OpenWRT recovery RS232